We have two slicers that we use to break up coal in our coal bunkers. The slicer plate is dropped onto the coal in the coal bunker. The slicer consists of a thick steel plate, roughly 24" x 18" x 4", attached to a wire rope (about 1/2" diameter). The wire rope runs from an air operated Ingersoll Rand winch mounted on a moveable base, and then up and over a 6 foot tall A-Frame mounted to the same base. The slicer plate is raised by the winch, and then dropped again to break up the coal. I believe the slicers are original from circa 1950, but I can't find any company name on them. They don't appear to be "home-made". Do you know any company that made such a device?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Coal Bunker Slicer
- Thread starter brianle
- Start date
If you desire to make the breaker from a work hardening alloy I would look at Astralloy-V. The use of AV or similar alloy would cost a little more but would never wear out.
MikeHalloran
Mechanical
Well, not 'never', but maybe another 60 years, in which case it wouldn't be your problem...
Mike Halloran
Pembroke Pines, FL, USA
Mike Halloran
Pembroke Pines, FL, USA
There is a possibility that it could be a casting. Check if it is non magnetic and let us know. You can cast it in high manganese steel and continue to use for the next half decade.(over statement)
If you think education is expensive, try Ignorance.
- Andy McIntyre
_____________________________________
If you think education is expensive, try Ignorance.
- Andy McIntyre
_____________________________________
- Thread starter
- #6
As suggested, I posted this in the Power Generating forum. I should have been clearer in what I wanted to know. What I was actually wondering about was whether the whole device with the hoist, frame, cart, slicer, etc. was made by a slicer manufacturing company. The slicer itself is made of layers of plate steel welded together.
MikeHalloran
Mechanical
I think we're trying to say that we don't know who might have made it, and since they didn't put their name on it, you may have to copy it and make it yourself.
Mike Halloran
Pembroke Pines, FL, USA
Mike Halloran
Pembroke Pines, FL, USA
- Status