Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Closed link connecting system to tank?

Status
Not open for further replies.

jriggs

Civil/Environmental
Joined
May 30, 2006
Messages
4
Location
US
I am trying to run a 24 hour trial for my system, but the link that connects the water tank to the system always has a status of closed even though i set it as open?? Any sugestions?


John
 
Are you using WaterCAD? Or other software (which)?

If it's WaterCAD, do you have "controls" set on it? Check the tab after the General tab.

Also, if the link isn't connected on both sides, or if the tank remains empty, it my reflect as closed.
 
Im using EPAnet. I set my parameters of the tank to full condition. How can I check and see if the tank is emptied when i run my analysis? Also if there might be some other problems, any info would be helpful.

John
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top