I would like to make a complete copy of an assembly and all of it's components and have all these files in one folder. I also want this copy to have ABSOLUTELY not connection to the original assembly and children from which it was created. Is the "cloning assemblies" a safe tool to use for this purpose. I do not have teamcenter. I am used to using Solid Edge and copying assemblies using revision manager.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cloning assemblies
- Thread starter chopper75
- Start date
Agrezar
Mechanical
- Feb 17, 2012
- 12
Just an FYI, my assemblies are very simular in structure, excluding job number, geometry, so i have created a "blank" assembly with job number 0000. When i start a new job, I will clone this assembly with renameing the 0000 to <new job #>. Saves abit of time, and keeps prt based settings staic.
- Status
Similar threads
