Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Clear default action of project curve 1
- Thread starter Stamos87
- Start date
-
1
- #2
JohnRBaker
Mechanical
You can go to...
Preferences -> User Interface -> General
...and select the third item from the bottom of the dialog to 'Reset "Don't display this message again"'.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
Preferences -> User Interface -> General
...and select the third item from the bottom of the dialog to 'Reset "Don't display this message again"'.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Status