Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cleanliness of piles

Status
Not open for further replies.

KenCenaiko

Mechanical
Joined
Nov 5, 2007
Messages
2
Location
CA
What is the approved method to prepare a reinforced concrete pile for either a pile cap or grade beam?

The concrete piles in question have re-bar protruding from the pile cap, but I am concerned about the amount of residual soil remaining on top of the pile prior to pouring the cap. These piles will be supporting 40 ton cranes and my contractor does not seem concerned about the cleanliness of the pile "tops". Any advice? Are bonding agents typically applied to the top of the pile?
 
Bang exposed rebar once with 2 lb hammer. Then place concrete.
 
It's not going anywhere pour and it will be fine.
 
If you're really worried, blow it out with compressed air.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top