MAPower
Mechanical
- Feb 16, 2007
- 29
I was looking to see what reccomendations/options anyone had on cleaning a new steam supply for a 1st point feedwater heater after construction. I have been looking at some startup documents, but no good information is available for feedwater supply lines (lots on main steam line "steam blows"). Would a basic flush or alkaline cleaning be sufficient? Some information on the system:
- system contains 5x feedwater heaters, deaerator, and condensate polisher
- coal fired unit
- this will be a secondary mainsteam supply to the 1st point feedwater heater
Thanks for the help.
- system contains 5x feedwater heaters, deaerator, and condensate polisher
- coal fired unit
- this will be a secondary mainsteam supply to the 1st point feedwater heater
Thanks for the help.