Poorpaulus
Automotive
Is there a way of representing the circular lines on a drawing if there are only two holes? The command doesn't really come alive unless three holes are selected. I need to dimension them radially.
Paul.
Paul.
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Circular Centre Marks on two holes
- Thread starter Poorpaulus
- Start date
