Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing decimal place in V5 hole table 1

Status
Not open for further replies.

sleske

Mechanical
Joined
Jul 18, 2006
Messages
53
Location
US
O.K. Here's the problem. Did work on a job and dim'd everything out in MM. Now, we generate hole charts when we draft out the tools. Of course, the chart is in MM's, But, the customer wants the hole chart in inches. Now, I've figured out how to generate the chart in inches, but it only goes out 2 decimals places. How do I change how many decimal places the chart generates?

Thanks,

Sean
 
Found out I'm an idiot. The simplest of answers is, of course, the right answer. Took me 3 hours and my boss 10 min. to figure out I need a vacation.
Thanks to any who may have been trying to figure this out.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top