M
mikedrever
Guest
Hi,
The title is wrong, sorry.
It should be center of gravity relative to assembly coordinate system, not COG. Sorry.
When I put the COG_X, Y, Z values in a repeat region on a drawing it shows the parts COG relative to the parts local coordinate system.
I want it to show the COG relative to the assembly coordinate system.
I tried selecting a different CSYS when running the Mass Properties report, but it still shows the COG for the parts as if I ran the same report in the part file alone.
I have seen other threads that talk about showing the COG in a drawing, but I didn't see one that addressed this specific issue. If I am in error I apologize.
Thanks for your help.
Mike
The title is wrong, sorry.
It should be center of gravity relative to assembly coordinate system, not COG. Sorry.
When I put the COG_X, Y, Z values in a repeat region on a drawing it shows the parts COG relative to the parts local coordinate system.
I want it to show the COG relative to the assembly coordinate system.
I tried selecting a different CSYS when running the Mass Properties report, but it still shows the COG for the parts as if I ran the same report in the part file alone.
I have seen other threads that talk about showing the COG in a drawing, but I didn't see one that addressed this specific issue. If I am in error I apologize.
Thanks for your help.
Mike
