Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CDB and ‘prnsol,s’

Ahmed_abdelgawad

Ahmed_abdelgawad

Mechanical
Joined
May 30, 2023
Messages
9
Location
AE
Hi everyone,


I'm currently working with Franc3D and need to export residual stresses from ANSYS Workbench as a .SRT file using the PRNSOL,S command. Additionally, I need to save the entire model as a .CDB file.


I'm not sure where to begin with this process—any guidance or step-by-step instructions would be greatly appreciated.


Thank you in advance!
 
You must log in or register to reply here.

Similar threads

W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
V
  • Locked
  • Question Question
Boundary conditions and post processing for Planar tension test
Replies
0
Views
578
vsw
V
IJR
  • Locked
  • Question Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
1K
IJR
IJR
LIAM_7
  • Locked
  • Question Question
ANSYS and fatigue analysis
Replies
0
Views
431
LIAM_7
LIAM_7
pmbov
  • Locked
  • Question Question
ANSYS Mechanical and Max Cores
Replies
0
Views
541
pmbov
pmbov

Part and Inventory Search

Sponsor

Back
Top