H
helio.b.teixeira
Guest
Hi,
Is there any chance to improve CATIA's graphics? Holes in model seem to be "polygonised"
Is there any chance to improve CATIA's graphics? Holes in model seem to be "polygonised"
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
- Status
- Thread starter
- #2
F
flanakins
Guest
Go to Options from the Tools dropdown. In the "Options:General
isplay"
open up the register "Performances" Here you should adjust the "3D Acuracy"
My best result is to set "Fixed" at 0.01. If your graphic card is powerful enough you shouln't notice any performance loss.
You can also experiment with the "Curve's Accuracy Ratio" I have mine set to
1.00x3D accuracy.
Fine tuning can be accomplished by playing with the "Level of detail" in the
area of "static" and "whilst moving".
As long as your models are not extra large and your graphic card is good you can obtain really realistic and accurate results.
Hope this helps
isplay"open up the register "Performances" Here you should adjust the "3D Acuracy"
My best result is to set "Fixed" at 0.01. If your graphic card is powerful enough you shouln't notice any performance loss.
You can also experiment with the "Curve's Accuracy Ratio" I have mine set to
1.00x3D accuracy.
Fine tuning can be accomplished by playing with the "Level of detail" in the
area of "static" and "whilst moving".
As long as your models are not extra large and your graphic card is good you can obtain really realistic and accurate results.
Hope this helps
- Status
