Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Catia Beginner - Creating a boundary surface

  • Thread starter Thread starter Sally Alzaim
  • Start date Start date
S

Sally Alzaim

Guest
Hello everyone. I am just moving on from solid works and I was wondering if there was a way to create a boundary surface between 2 profiles like the green border shown in the attached photo. In SW you can just choose boundary surface and chose the 2 directions (including the small corner). How do I go about this on Catia??

thanks
SallyView attachment 2417
 

Attachments

  • Capture.jpg
    Capture.jpg
    19.3 KB · Views: 6
I'm not that familiar with a SW Boundary Surface, but I think it's similar to a CATIA Multi-Section Surface or a Sweep Surface
 
You may also try using a Fill but the fill command needs a closed boundary.
 

Part and Inventory Search

Sponsor

Back
Top