CATIA 17 problem setup

[MohammadAtteya]

When trying running CATIA V5 R17 a "Click Ok to terminate" message appears, is that because my machine has DDR1 RAM?

 

[JuhaEdag]

No it's probably because you're running an illegal copy!

 

[tuzoenduro]

Ignore JuhaEdag's comment, CATIA can break off and stop for a whole number of reasons, legal copy or not.
If it does this very often verify that your computer setup is up to code and everything you have is properly certified by Dassault. You can check on their site for you grafic card and memory and whatnot.
Other than that, it can be a problem of need of memory, a problem with your pieces, between other reasons.
If all else fails, call Dassault's assistance, or your local reseller.

 

[MohammadAtteya]

thanks so much tuzoenduro

 

[DaveSumm]

'click ok to terminate' happens on IBM built certified machines. Not just normal pc's. Try using a later service pack