H
Horwarth19
Guest
Here's an interesting question that I haven't been able to figure out. I have to
create some casting core's in order to do the model that I am working on. It
isn't an issue to create them as they are drawn. The issue is getting the
drawing to look the way that it should. When I model them, I model them as a
solid, and then I will merge them into the casting and cut it out. Is there a
way for me to get the core prints to look as below?
View attachment 5321
create some casting core's in order to do the model that I am working on. It
isn't an issue to create them as they are drawn. The issue is getting the
drawing to look the way that it should. When I model them, I model them as a
solid, and then I will merge them into the casting and cut it out. Is there a
way for me to get the core prints to look as below?
View attachment 5321
