Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cast in place Girder - abutment details

Status
Not open for further replies.
RFreund

RFreund

Structural
Joined
Aug 14, 2010
Messages
1,885
Location
US
I apologize for the vagueness of this question, however I was looking for DOT details for a cast in place girder / abutment bearing detail (allowing for horizontal movement). Specifically IDOT, but I've looked there and can't seem to come up with much. I suppose it would be similar to the precast detail except cast in the field?

EIT
 
Status
Not open for further replies.

Similar threads

tmalik3156
  • Question Question
Old Through Plate Girder Bridge
Replies
10
Views
16K
BridgeSmith
BridgeSmith
tmalik3156
  • Locked
  • Question Question
Retrofit of stub abutment
Replies
2
Views
2K
BridgeSmith
BridgeSmith
bridgebuster
  • Locked
  • Question Question
Semi-integral Abutment Design
Replies
6
Views
1K
bridgebuster
bridgebuster
tmalik3156
  • Locked
  • Question Question
Encampment deterrent for steel girder bridge
Replies
9
Views
5K
tmalik3156
tmalik3156
ATHS
  • Locked
  • Question Question
Notch in girder flanges
Replies
2
Views
414
BridgeSmith
BridgeSmith

Part and Inventory Search

Sponsor

Back
Top