Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cast A frames

Status
Not open for further replies.
sbi

sbi

Industrial
Joined
Sep 25, 2000
Messages
103
Location
US
Looking for a PE that can look at a design, and give a Yea/ nea, and suggestions to a design that used a Aluminum casting for the front upper and lower's

can contact direct @ bill@phxgrp.com
For more info Thank you!
 
Status
Not open for further replies.

Similar threads

ksw100
  • Locked
  • Question Question
Determining Maximum Acceptable Play in Bushings / Spherical Bearings for a Hobbyist Track Car Build?
Replies
4
Views
1K
cibachrome
cibachrome
LostInTransit
  • Locked
  • Question Question
[Confirmed Fitment] 28mm Hardrace sway bar (designed for a 2019 Ford Kuga) will fit the 2020 Ford Connect
Replies
0
Views
1K
LostInTransit
LostInTransit
ksw100
  • Locked
  • Question Question
I have a couple questions about bump scrub (i.e. track width scrub).
Replies
5
Views
1K
GregLocock
GregLocock
C6H5CH3
  • Locked
  • Question Question
Aluminum Monocoque for a production vehicle
Replies
4
Views
577
GregLocock
GregLocock
LostInTransit
  • Locked
  • Question Question
Debunking a Rumor
Replies
3
Views
537
LostInTransit
LostInTransit

Part and Inventory Search

Sponsor

Back
Top