Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cant select elements or nodes in FE Modeller

Status
Not open for further replies.
DrBwts

DrBwts

Mechanical
Joined
Nov 4, 2012
Messages
297
Location
GB
ANSYS 17.1

I have imported an Abaqus beam mesh via the FE Modeller component but I cant select any of the nodes or elements in the graphics window.

FEM_ANSYS_Selction_issue_ssntgw.png
 
Status
Not open for further replies.

Similar threads

Tegguy
  • Locked
  • Question Question
ANSYS: Beam Elements vs Joint Stiffness?
Replies
11
Views
2K
Tegguy
Tegguy
andradesilva
  • Locked
  • Question Question
modal analysis in ANSYS Mechanical APDL 2020 R2: How to see graphical results without mesh/elements
Replies
1
Views
909
NRP99
NRP99
andradesilva
  • Locked
  • Question Question
how to select a cross-section for a line built in Design Modeler in ANSYS workbench 2023 R1
Replies
0
Views
314
andradesilva
andradesilva
vickyiamlucky
  • Locked
  • Question Question
Ansys Symmetry model to full model cut boundary dispacemnt or force bc
Replies
0
Views
721
vickyiamlucky
vickyiamlucky
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H

Part and Inventory Search

Sponsor

Back
Top