Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cannot see Points!

Status
Not open for further replies.

MaxShiff

Aerospace
Joined
Apr 20, 2002
Messages
17
Location
CA
Whenever I am in Part Design mode, and I create a point, I can never SEE that point in my 3D space...does anyone know how I can adjust the visualization to see these points???

Thanks,


Max
maxshiff@sympatico.ca
 
(I am using V5R8, by the way...)
 
mostlikely it caused by your graphic card, some cards do not support catia well.
 
You should check Options - General - Display - Performances - Level of Detail value.
Smaller value means better level of detail (I think)

 
Make sure your "Open Body" is not in "No Show".
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top