Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Can you see if all parts in BOM have mass properties?
- Thread starter hornwm1
- Start date
If you are looking to see if your parts have the correct densities set you can add the MP_DENSITY column to the model tree. You can then view and if necessary change any densities for the entire assembly model from the model tree.
Hope this helps,
Ron
Hope this helps,
Ron
- Status
Similar threads
- Question
- Locked
- Question