Can the dim/modify dialog box be turned off when dimesioning? 1

[aroundhere]

While sketching... when you dim something, the (modify) dialog box pops up to allow you to change the dim if needed. Sometimes this slows me down, since I import alot of acad sketches and know that they are already the desired dim. Is there a way to turn this on and off?

thanks

 

[CorBlimeyLimey]

Go to Tools > Options > System Options > Sketch and deselect Enable onscreen numeric input on entity creation

 

[MikeMcL]

CBL, I think he wants Tools>Options>System Options>General> and deselsect Input dimension value.

 

[CorBlimeyLimey]

Mike ... You are probably correct.

 

[aroundhere]

that did it guys. Thanks again as always. I was looking under dimension settings instead of general.