Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

can someone guide me when to use UG

Status
Not open for further replies.
Tirth

Tirth

Mechanical
Joined
Mar 14, 2022
Messages
1
Location
IN
can someone guide me when to use UG-39(b)(3)
 
Sort by date Sort by votes
Can you be more specific?

The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

YuJie_PV
  • Locked
  • Question Question
Membrane or Membrane+Bending when assessing local failure protection per ASME VIII-2
Replies
8
Views
7K
YuJie_PV
YuJie_PV
EMANUELE GUERRINI
  • Locked
  • Question Question
ASME I Boiler with 15 PSI Pressure - Can I Use an ASME IV Safety Valve?
Replies
2
Views
863
The Obturator
The Obturator
JoeSeag
  • Locked
  • Question Question
ASME VIII UG-44(b)
Replies
16
Views
4K
TGS4
TGS4
Mech_ash19
  • Locked
  • Question Question
ASME VIII-1 UG-44(b) - External Loads on Standard Flange - Analysis Options for Slip-On Flanges
Replies
2
Views
1K
Mech_ash19
Mech_ash19
sshep7
  • Locked
  • Question Question
SA-53 E/B used as a vessel shell Section - UW-12(e) UW-12(d), UW-11(a)(5)(b) and what JE to use
Replies
4
Views
625
david339933
david339933

Part and Inventory Search

Sponsor

Back
Top