Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

can someone guide me when to use UG

Status
Not open for further replies.
Tirth

Tirth

Mechanical
Mar 14, 2022
1
can someone guide me when to use UG-39(b)(3)
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Can you be more specific?

The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

YuJie_PV
  • Question
Membrane or Membrane+Bending when assessing local failure protection per ASME VIII-2
Replies
8
Views
6K
YuJie_PV
YuJie_PV
EMANUELE GUERRINI
  • Locked
  • Question
ASME I Boiler with 15 PSI Pressure - Can I Use an ASME IV Safety Valve?
Replies
2
Views
694
The Obturator
The Obturator
JoeSeag
  • Locked
  • Question
ASME VIII UG-44(b) 4
Replies
16
Views
3K
TGS4
TGS4
sshep7
  • Locked
  • Question
SA-53 E/B used as a vessel shell Section - UW-12(e) UW-12(d), UW-11(a)(5)(b) and what JE to use
Replies
4
Views
433
david339933
david339933
Mech_ash19
  • Locked
  • Question
ASME VIII-1 UG-44(b) - External Loads on Standard Flange - Analysis Options for Slip-On Flanges 1
Replies
2
Views
826
Mech_ash19
Mech_ash19

Part and Inventory Search

Sponsor

Back
Top Bottom