I am looking for standard of calculating the torque force need to fasten nut and bolt (standard nuts A194 all grade and standard bolt A193 all grade, all sizes) of piping flanges or some equipment such as towers or rectors in both condition cold and hot bolting that have metallic gasket (such as spiral wound gasket 304/graphite)
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
calculation of torque force needed for fastening blots
- Thread starter alizali
- Start date
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
