Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

cage to slip ring

Status
Not open for further replies.
kunalw

kunalw

Electrical
Apr 21, 2000
22
how to go for cage to slpring.<br>procedure is required .<br>thanking you for responding
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The Slipring motor has better torque caracteristics than cage motor.So Slip motor can definately replace cage motor.But you will have to intall a manul/Auto 3 or 4 steps starter for Slipring motor rotor. <br><br>Regards <br>Khalid Khan
 
Upvote 0 Downvote
The Slipring motor has better torque caracteristics than cage motor.So Slip motor can definately replace cage motor.But you will have to intall a manul/Auto 3 or 4 steps starter for Slipring motor rotor. <br><br>Regards <br>Khalid Khan
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

freetown
  • Locked
  • Question
Uncoupled slip-ring induction motor speed
Replies
6
Views
3K
FacEngrPE
FacEngrPE
NickParker
  • Locked
  • Question
Rotor ground faults without slip rings
Replies
3
Views
2K
wcaseyharman
wcaseyharman
freetown
  • Locked
  • Question
Wound rotor/squirrel cage with VFD 1
Replies
6
Views
4K
waross
waross
itsmetinnie
  • Locked
  • Question
Squirrel Cage motor with space heater and PTC 1
Replies
3
Views
957
che12345
che12345
electricpete
  • Locked
  • Question
Portable antenna-based EMI detection of arcing at wound rotor motor slip rings? 1
Replies
5
Views
373
waross
waross

Part and Inventory Search

Sponsor

Back
Top Bottom