Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

cage reinforcement

Status
Not open for further replies.
monchie

monchie

Structural
Joined
Feb 22, 2011
Messages
96
Location
IE
Hello,

When I model a simple rc beam with "point" pinned support, I cannot see its "cage reinforcement"(the actual rebar graphics display) but when I replace the point support with a rc column, I can see its cage reinforcement when I run the "detailing" option. Is there any reason for this? Any ideas will be greatly appreciated.

Regards,
 
Status
Not open for further replies.

Similar threads

Robert-32
  • Locked
  • Question Question
Core and shear wall transverse reinforcement
Replies
0
Views
440
Robert-32
Robert-32
WAFAPEGO
  • Locked
  • Question Question
Differences in column longitudinal reinforcement - ETABs Detailed Design Reports.
Replies
0
Views
245
WAFAPEGO
WAFAPEGO
Vito11
  • Locked
  • Question Question
Excessive Shear Reinforcement in Spandrel Design to AS3600-2018
Replies
0
Views
193
Vito11
Vito11
Penpendrum
  • Locked
  • Question Question
Etabs column longitudinal reinforcement placement
Replies
0
Views
198
Penpendrum
Penpendrum
Luis camposano
  • Locked
  • Question Question
SECTION DESIGNER THE ETABS HAS PROBLEMS WHEN DESIGNING SECTIONS WITH REINFORCEMENTS
Replies
2
Views
816
engineering_patrol
engineering_patrol

Part and Inventory Search

Sponsor

Back
Top