Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

BWE Sch.XXS Small valve

Status
Not open for further replies.
Isha90

Isha90

Mechanical
Joined
Dec 21, 2017
Messages
88
Location
IN
Customer requirement 1"Cl.2500 T-Globe BWE Sch.XXS, can we reduce valve flow bore from 19.1 to 14mm for achieving BWE ID. Is it acceptable as per ASME B16.34
 
Sort by date Sort by votes
IMO, the valve manufacturer should be consulted for the correct answer.
Per B16.34, the requirement of the bore diameter "d" is per Section 6.1.2, and it is corresponded to the required wall thickness "tm" per 6.1.1 and Table 3.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Inchtain
  • Question Question
Seat Rings of small and big size ball valves
Replies
3
Views
3K
Danlap
Danlap
A
  • Question Question
Use of Gate Valve for Throttling
Replies
13
Views
12K
georgeverghese
georgeverghese
trentar
  • Question Question
example of 12516 valve design calculations
Replies
0
Views
8K
trentar
trentar
35jacob35
  • Locked
  • Question Question
Valve Paint Aplication
Replies
3
Views
3K
SJones
SJones
neroverdi41
  • Locked
  • Question Question
Pressure Control Valve vs Flow Control Valve
Replies
11
Views
6K
Taicho567
Taicho567

Part and Inventory Search

Sponsor

Back
Top