Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bulk Items BOMS Inseperable Assemblies

Status
Not open for further replies.

iongrl

Mechanical
Jun 27, 2001
1
US
Greetings,
I'm a new user and have created an inseperable assembly, I need to add loctite to the bom parametically. Some one told me to create componet bulk item in assembly mode which I did. The drawing bom has a new line but I am unable to edit or get the part number to show. Can anyone assist?


Iongrl
 
Replies continue below

Recommended for you

For the Pro/REPORT variables used, your repeat region variable should use assembly type report "variables". But, I think this will mess up your regual pro/report fields.

You can also simply assembly a component to the assembly that has no geometry but, just the parameters to complete your repeat region.

 
You should create a mass component inside assembly mode.
(Also available under the popUp-menue in modelltree.)
requires Pro/Assembly
This creates a part which only can be used with the specific assembly used in.
You might need to have your specific parameters so:

Set Up >Parameters>Component | Part>Sel By Menue

You also can create parameters by changing the modelltree with all your parameters displayed:

click on the parameter field to specify the parameter.


 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top