Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Building drift and diaphragm deflection limits

Status
Not open for further replies.

jnichol

Structural
Joined
Oct 23, 2001
Messages
11
Location
US
Where do I find some good information (with a picture preferably) on

1. Building VLLR drift limits
2. Diaphragm deflection limits between the MFRS.

I have design guide 3, but that all seems greek. What do they mean drift perp to wall? Which wall, the shearwall or the wall which is perp to this wall. I know you always hear h/400 for the VLLR, but why. Where is that written in stone, and why can a prefab building drift so much more.

Thanks for any help.
 
Depends on what you are designing for. There are seismic drift limits in the IBC code. Design guide 3 is for serviceability and yes it is very hard to read. Pre-Engineered metal buildings are allowed a limit of L/120 regardless of cladding, which I think is a political thing...lobbyists and all for the metal building association. If you have masonry veneer, then you should use somewhere between L/600 and L/480. A masonry association recommends L/730, but that gets a little crazy. I would use design guide 3 except I would use the masonry veneer limit above. Another thing you can consider is you wind speed. It is based on a 50yr occurrence. Who cares if your brick cracks a little in 50 yrs. You can adjust your serviceability design wind speed by converting it to a 10 yr wind speed and reduce your wind speed by around 30%. The conversion chart is in the back of ASCE 7. Makes a pretty big difference if you can't meet your serviceability drift limit. You still want to set your strength limit using the standard wind speed.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top