Shahroze Mustafa
Mechanical
What is the procedure for Mechanical Design of Bubble tight leak dampers? What are there designing codes and Is there any software available for Design?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bubble Tight Leak Dampers
- Thread starter Shahroze Mustafa
- Start date
- Status
What size is your pipe/ductwork ?
You may be forced into considering a circular cross section in order to use commercially available large butterfly valves...
Oh, wait ..... the rectangular ductwork has already been installed, right ???
MJCronin
Sr. Process Engineer
You may be forced into considering a circular cross section in order to use commercially available large butterfly valves...
Oh, wait ..... the rectangular ductwork has already been installed, right ???
MJCronin
Sr. Process Engineer
- Thread starter
- #3
Shahroze Mustafa
Mechanical
Dampers Size Ranges from 16'' to 54''?.
Is there any method of how to design their key components like flange width and thickness, hub length, shaft dia etc?
Is there any method of how to design their key components like flange width and thickness, hub length, shaft dia etc?
You could purchase one of these products ...
But, whatever you do, please do not use the words "Please" or "Thank You in your posts and ignore everything said after you get what you want ....
MJCronin
Sr. Process Engineer
But, whatever you do, please do not use the words "Please" or "Thank You in your posts and ignore everything said after you get what you want ....
MJCronin
Sr. Process Engineer
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question