Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Broaching ETD 150

Status
Not open for further replies.
pdybeck

pdybeck

Mechanical
Joined
May 14, 2003
Messages
599
Location
US
I am interested in anyone's experience in broaching ETD 150. The broach would be between a 3/8" - 1/2" Hex by 1/2" deep. Material hardness of ETD 150 may pose difficulties in broaching, but I am not sure as it seems to be on the edge. Does anyone have any experience?

Pete
 
Sort by date Sort by votes
It will be similar to 4140 HT. Slower speeds, shorter depths of cut, and a good setup will provide success
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

rafal222
  • Locked
  • Question Question
150 mm Angle Grinder Dust Collection guard- help
Replies
2
Views
238
racookpe1978
racookpe1978
calincandea
  • Locked
  • Question Question
UNION BFK 150 horizontal milling machine
Replies
1
Views
93
MikeHalloran
MikeHalloran
tripleZ
  • Locked
  • Question Question
Broaching question
Replies
15
Views
378
EdDanzer
EdDanzer
luky
  • Locked
  • Question Question
broaching
Replies
0
Views
65
luky
luky
cmcgonag
  • Locked
  • Question Question
Low RPM (15000) r134a turbine
Replies
6
Views
174
dcasto
dcasto

Part and Inventory Search

Sponsor

Back
Top