I want to braze or solder tubes (made from marine grage brass) to tubesheets (marine brass as well)in boat heat exchanger. The two above technologies seem easy, but I am seeking the most corrosion resistant way-out. Is silver solder (45 % Ag) resistant enough? Maybe something different should be considered? Any advice will be very helpful.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
brass brazing
- Thread starter shermick
- Start date
- Status
Similar threads
