Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Boring canned cycle

Thread starter blaineam
Start date Feb 3, 2014

Status: Not open for further replies.

Feb 3, 2014

blaineam

Aerospace

I am fixturing a part to bore the holes and bushings with a boring head. I am wanting to make it so it will 1)bore the hole 2)dwell and stop the spindle at the bottom of the hole 3) orient spindle 4)move Y .015 5) then retract out of the hole. I have looked in the places I was hoping to find the answer and have had no luck. Hopefully someone can shed some light on this. Also G88 where the operator has to manual move and retract the spindle is not an option.

Thanks for any and all help that comes.