I installed a 24VDC battery supplying a scada panel. The battery is sitting on a steel rack built for the purpose. Inspections say I need to ground (bond) the rack but cannot site a code (NEC) article that is applicable. Is there a code article that applies to this installation?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bonding 24VDC Battery Rack
- Thread starter mark5703
- Start date
In most countries it is a requirement to bond all metal surfaces in electrical installations, that people may come in contact with. Actual regs are different in country to country but the essence is the same. Anyway it is good design to do this for protection and EMI/EMC issues.
- Status
Similar threads
- Locked
- Question
- Question
- Question
- Locked
- Question