May 14, 2008 #1 Fixturedesign Mechanical Nov 20, 2002 40 Where is the BOM contents window (SolidWorks 2008)? In 2007 you could use this to validate that all items have balloons.
Where is the BOM contents window (SolidWorks 2008)? In 2007 you could use this to validate that all items have balloons.
May 14, 2008 #2 handleman Automotive Jan 7, 2005 3,411 Click in the area on the left side of the BOM. A flyout area will appear showing the information previously shown in the BOM Contents window. -handleman, CSWP (The new, easy test) Upvote 0 Downvote
Click in the area on the left side of the BOM. A flyout area will appear showing the information previously shown in the BOM Contents window. -handleman, CSWP (The new, easy test)
May 14, 2008 Thread starter #3 Fixturedesign Mechanical Nov 20, 2002 40 OK - I found what you are talking about - the graphics quality was horrible, and it relys on the zoom level you are at. A little awkward, but I'll try to adapt (like I have a choice). Thanks Upvote 0 Downvote
OK - I found what you are talking about - the graphics quality was horrible, and it relys on the zoom level you are at. A little awkward, but I'll try to adapt (like I have a choice). Thanks
