Wondering if the Solidworks Simulation Connector feature takes into account member vs. bolt stiffness when calculating Connector Forces (i.e. using the joint stiffness coefficient 'C'). If so, the axial Connector force SW outputs should = preload + C*(applied load). Getting wacky numbers and curious if anyone has a better understanding of the SW Connector Force calculation process. Thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bolted Joint Stiffness Analysis in SolidWorks Simulation
- Thread starter matt_j
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question