Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

BMD and SFD for Two saddles of a Heat Exchanger.

Status
Not open for further replies.
DK44

DK44

Mechanical
Joined
Sep 20, 2017
Messages
196
Location
IN
How to make BMD and SFD for Two saddles of Heat Exchanger with PV Elite calculation results.
How to use PV Elite results for this purpose?
 
Sort by date Sort by votes
BMD? SFD? Too obscure for me :)

The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
Upvote 0 Downvote
Dear SnTMan.
I mean
BMD = Bending Moment Diagram
SFD = Shear Force Diagram.
 
Upvote 0 Downvote
DK44, I am no PVE expert, but I don't think you can get those from, say, the Zick output. That would be a question better put to Coade / Intergraph / Hexagon (or whoever is current) IMO.

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Whin
  • Question Question
Heat Exchanger one stream out of service
Replies
3
Views
602
LittleInch
LittleInch
Ronak_Patel
  • Locked
  • Question Question
commercial software for design of pressure vessel and heat exchanger according to ASME SEC ||| for nuclear application.
Replies
1
Views
5K
MJCronin
MJCronin
D
  • Locked
  • Question Question
DESIGN CRITERIA FOR BEM TYPE HEAT EXCHANGER
Replies
0
Views
1K
Dinesh2600
D
MchA
  • Question Question
TEMA DEU/CEU Heat Exchanger - Connection Challenges & Analysis
Replies
18
Views
24K
r6155
r6155
FPPE
  • Locked
  • Question Question
SA-182 VS SA-965 for heat exchanger tubesheets and girth flanges
Replies
14
Views
7K
r6155
r6155

Part and Inventory Search

Sponsor

Back
Top