Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Blow molding tolerances

Status
Not open for further replies.
JoJoBlue

JoJoBlue

Mechanical
Joined
Jul 20, 2011
Messages
3
Location
CA
Hello,

I usually use DIN16901 as a reference for giving tolerances to injection molded parts. But recently, I've been given a part that is to be blow molded. I'm wondering if there is a similar set of standards or guidelines for blow-molding tolerances?

Thanks
 
Sort by date Sort by votes
It doesn't matter.

Blow molders just give you a blank stare when you mention tolerances.



Mike Halloran
Pembroke Pines, FL, USA
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Buckshott00
  • Locked
  • Question Question
Process Setting for Improved Over-molding to prevent delamination In Molded Hytrel
Replies
0
Views
968
Buckshott00
Buckshott00
breezy83
  • Locked
  • Question Question
Long Internal Cavity Injection Molding Question
Replies
3
Views
378
Pud
Pud
Azzazil
  • Locked
  • Question Question
Tolerances between parts of mold for injection molding
Replies
0
Views
291
Azzazil
Azzazil
pf26
  • Locked
  • Question Question
Low pressure injection molding - material performance for hinge design
Replies
4
Views
581
pf26
pf26
subsearobot
  • Locked
  • Question Question
risky 2 shot molding! ADVICE PLEASE
Replies
3
Views
348
dgallup
dgallup

Part and Inventory Search

Sponsor

Back
Top