Has anyone had a compatibility problem with block insert nodes becoming unusually large when running AutoCad with Bentley AutoPlant. The nodes will shrink if I regenerate the drawings; however, they will not completely go away. The blocks that are creating the problems are objects that are 3D solids or surfaces. When attempting to print the objects, a very small box appears at the insert point. Any suggestions of how to suppress the insertion points?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Block Insertion Nodes Showing 1
- Thread starter CRG
- Start date
- Status