Blank Sketch Dimension in NX 4

[retatton]

I am trying to blank a sketch dimension in NX 4 so that when I come back into the sketch, it is still gone. All methods I have tried will blank the dimension until I exit the sketch and then come back in.

 

[Xwheelguy]

Might wanna search a little bit before asking the same question on the same day:

http://www.eng-tips.com/viewthread.cfm?qid=178738&page=1

Tim Flater
Senior Designer
Enkei America, Inc.

http://www.enkei.com

Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs.

 

[retatton]

I realize there is another post with the same content, however when I searched on this forum for "blank dimensions", "hide dimensions", etc. that thread did not come up.

I apologize for the repeat post.