rika kose
Chemical
- Jun 11, 2019
- 71
Hello everyone,
An old tank at my client is equipped with bevel end nozzle on top of the tank used as inlet nozzle DN50.
bevel end angle 60º. (sketch attached)
According to the original design, this nozzle will divert the flow direction to the center of the tank.
In my opinion, this will not work as it is described.
I didn't find more information about this type of nozzle.
Will the nozzle change the direction of the flow?
Link
An old tank at my client is equipped with bevel end nozzle on top of the tank used as inlet nozzle DN50.
bevel end angle 60º. (sketch attached)
According to the original design, this nozzle will divert the flow direction to the center of the tank.
In my opinion, this will not work as it is described.
I didn't find more information about this type of nozzle.
Will the nozzle change the direction of the flow?
Link
