Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Best callout for pinning to shaft together?

Status
Not open for further replies.

CANDOR

Mechanical
Nov 16, 2005
1
I have a hollow shaft and a solid shaft that I want to pin together. I'm looking for GD&T callout that will make sure that the pin hole will be drill thru center of both dia's. So went I go to pin the part together the hole's will be in-line with each other.


Thanks
 
Replies continue below

Recommended for you

Maybe true position is correct, we do this as assembly step (press together to dimension A, drill thru on center at distance B, insert pin) so GD&T is not truely important for us.
 
We have a similar part. It is a weldment (cam & bore) that slides over the pin (solid part) of a motor and are aligned with a rollpin. We just made the angular dimension of the cam in the weldment a Basic Dimension.

[green]"I think there is a world market for maybe five computers."[/green]
Thomas Watson, chairman of IBM, 1943.
Have you read faq731-376 to make the best use of Eng-Tips Forums?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor