Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bending Thin Walled Extrusions

Thread starter sairsk
Start date Aug 25, 2005

Status: Not open for further replies.

Aug 25, 2005

sairsk

Industrial

sairsk (Industrial) 24 Aug 05 15:06
We have to radius a thin walled Aluminium channel. Have any one got some information regarding how to bend tubes and pipes by encapsulating them in some low melting point alloy?? Would appreciate your suggestions and ideas.

Material : Aluminium

Temper: T5

Thickness: 0.08