Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bending moment output for plates

Status
Not open for further replies.
naimjnpierre

naimjnpierre

Civil/Environmental
Joined
Dec 12, 2007
Messages
3
Location
LC
I have modelled a ground slab on soil springs but i cannot interpret the results from SAP. SAP's output is in the form of force/moment contours which are given per unit of inplane length. Can someone explain how i can get my design moment?
 
Status
Not open for further replies.

Similar threads

giofed
  • Locked
  • Question Question
SAP 2000 Shell twisting moment
Replies
1
Views
1K
JoshPlumSE
JoshPlumSE
a_urbs
  • Locked
  • Question Question
Using Section Cuts in SAP for Storey Weight
Replies
0
Views
1K
a_urbs
a_urbs
J
  • Locked
  • Question Question
Question about the definition of transfer beams in a pile cap for a pedestrian bridge foundation
Replies
0
Views
2K
jcarlosamao
J
juandavidguzman
  • Locked
  • Question Question
SAP2000 Nonlinear Analysis Setup for Steel Design: Notial loads
Replies
2
Views
2K
STpipe
STpipe
A
  • Locked
  • Question Question
CSI BRIDGE "Design request" for Precast Concrete I Girder bridge does not work when the defined beam is nonprismatic !!!
Replies
0
Views
881
Abderrahmane Mche
A

Part and Inventory Search

Sponsor

Back
Top