bend table -"other" angles

[ymerej]

I saw a similar question posed in an earlier thread, but no answer. Does anyone know if there is a way to include other angles in the bend tables? I'd like to be able to add bend deduction numbers for angles other than 90.

 

[CorBlimeyLimey]

If the thickness of the part or bend angle falls between values in the table, the software interpolates the values to calculate the bend allowance.

Eng-Tips.com Forum Policies faq731-376
Making the best use of this Forum. faq559-716
How to get answers to your SW questions. faq559-1091
Helpful SW websites every user should be aware of. faq559-520

 

[hisrik]

As CorBlimeyLimey said, just work your way back using the concept of ratio! It works!