Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Below Knee Prosthetic Analysis Closing with no Fatal Errors

Status
Not open for further replies.
mbrownin

mbrownin

Bioengineer
Dec 1, 2008
1
We are currently trying to analyze a below knee prosthetic. When I do the analysis, a window comes up that says "msengine.exe has stopped working." When I click "Close the program," the analysis stops running, and the diagnostics appear with no fatal errors. This happens about 10 minutes into the analysis, when AutoGEM is fixing problems. What am I doing wrong, and what can I do to make the analysis go to completion?
 
Status
Not open for further replies.

Similar threads

jerry1423
  • Locked
  • Question
Creo dimension with limits 1
Replies
1
Views
875
looslib
looslib
mb0771sb
  • Locked
  • Question
Use rigid body with remote displacement
Replies
0
Views
732
mb0771sb
mb0771sb
Henry26
  • Locked
  • Question
How to perform FEA with GAP contact? 1
Replies
1
Views
481
kranmeste
kranmeste
ntoukis21
  • Locked
  • Question
Spiral bevel gear analysis 1
Replies
4
Views
303
ntoukis21
ntoukis21
Angothoron
  • Locked
  • Question
Assembly Problems Non-Linear Analysis
Replies
1
Views
322
shaun8567
shaun8567

Part and Inventory Search

Sponsor

Back
Top Bottom