Y
yuvionfire
Guest
Hi,
I am using pro - e wildfire 2.0 , my project is to analyze the load of the component there i want to apply the bearing load of my design component.I have seen that bearing load icon but its in disable. Just i want to know how to enable that icon? whether that option is not available in my current version of the software?
any one can suggest what should i do now?
Regards,
Yuvaraj.
Edited by: yuvionfire
I am using pro - e wildfire 2.0 , my project is to analyze the load of the component there i want to apply the bearing load of my design component.I have seen that bearing load icon but its in disable. Just i want to know how to enable that icon? whether that option is not available in my current version of the software?
any one can suggest what should i do now?
Regards,
Yuvaraj.
Edited by: yuvionfire
