Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SE2607 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Basic customization inquiry

Thread starter AAREng
Start date Mar 15, 2012

Status: Not open for further replies.

Mar 15, 2012

AAREng

Mechanical

I am having trouble setting my display to maintain visibility of the datum planes when I rotate the view holding down the middle mouse button. I was wondering if there is a way to make the datum planes visible during this operation. I also would appreciate if there is any literature or online tutorials that would help me develop my Pro/e ability (i am using pro/e wildfire 5.0)

Thank you!