Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

BALLOON EDGE BLEND

Status
Not open for further replies.
MARINA221171

MARINA221171

Mechanical
Jan 13, 2010
21
Hi All,

any edge blend radious range 2.1-2.9 mm creates the balloon shows the attachement.

very nice!!! but very strange too!!!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Try applying the blends separately. Blend the sharp ends of the boss feature then apply the root blend.
 
Upvote 0 Downvote
Very strange...
I don't think it's a stupid setting... those are preset. ;-)

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Halasox
  • Locked
  • Question
NXOPEN Add edge blend to each part in an assembly 3
Replies
2
Views
374
Halasox
Halasox
imti7
  • Locked
  • Question
How to give Full round edge blend or fillet choosing three faces? 2
Replies
8
Views
680
imti7
imti7
DDerek
  • Locked
  • Question
How to make "Balloon" Result in only the number for the callout
Replies
3
Views
457
SDETERS
SDETERS
vnet
  • Locked
  • Question
Native NX to Solid Edge 2
Replies
3
Views
401
Toost
Toost
Crocostimpy
  • Locked
  • Question
Blend Corner 1
Replies
17
Views
838
Toost
Toost

Part and Inventory Search

Sponsor

Back
Top Bottom