Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Balloon Catheter inflation

Status
Not open for further replies.
jetset1

jetset1

New member
Joined
Feb 14, 2013
Messages
1
Location
GB
Hello all,

I am trying to create and inflate a folded thin wall balloon catheter, and I am not entirely sure how to go about this, I have seen simulations of folded airbags being inflated but have no idea how this was achieved. Is this done through FEA or a motion study? Any ideas how I can make my model inflate?

Thanks in advance
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top