Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

B31.8 : PWHT Engineering calculation

Status
Not open for further replies.
narenr

narenr

Marine/Ocean
Joined
Aug 4, 2000
Messages
97
Location
EU
I am looking for software or procedures for performing engineering calculations required to avoid PWHT for pipe wall thickness exceeding 31.8mm as required by B31.8.


Narendranath R
narenr@narendranath.itgo.com
Pipeline engineering is made easy with state of the art computer software, visit
 
Status
Not open for further replies.

Similar threads

engineer0
  • Question Question
End Face Dimension - ASME B31.8 831.4.2(j)(3)
Replies
1
Views
3K
akpipelineengr
akpipelineengr
B
  • Locked
  • Question Question
B31.8 Location Design Factor Change
Replies
9
Views
4K
GD2
GD2
K
  • Question Question
Nozzle load calculation
Replies
2
Views
498
KevinNZ
KevinNZ
JARivera1
  • Locked
  • Question Question
ASME B31.3-2016 PWHT Exemption
Replies
6
Views
6K
JARivera1
JARivera1
engineer0
  • Question Question
ASME B31.8 831.4.2(c) vs. 831.4.2(j)(3) - Reinforcement members and Pressurized Sleeves, End face thicknesses & fillet welds
Replies
3
Views
3K
GD2
GD2

Part and Inventory Search

Sponsor

Back
Top